Solder water-silicone freely. Can be used to coordinate to create serum or cream texture.

HLB about 4.5

SiliSolve™ (PEG-10 Dimethicone, Odorless) Odorless GradeSolder the water to the silicone. freely Can be used to create serum or cream HLB about 4.5

The ratio of water in the formula is in the range of 70-99% (meaning that there is a proportion of all types of silicone 1-30%). If there is a lot of water in the formula It will make the formula texture highly thick.

SiliSolve™ can be used to solder In formulations containing electrolyte ingredients, there is no problem.

difference between SiliSolve™ and SiliSolve Plus™

- SiliSolve Plus™ can create a creamy texture with the coordination between Water-*Oil*-Silicone The formulation can contain up to 30% oil (this 30% total oil fraction includes silicones).

- SiliSolve™ Can synchronize between water-silicone (There may be a small amount of oil in the recipe. should not exceed 3%)

IMPORTANT - Mixing procedure

Mixing must bring the water. Add to the silicone part by adding a little at a time and blending or stirring continuously. If vice versa, add the silicone part to the water part. It will take much longer to stir or spin.

Detailed steps:

1. lead SiliSolve™ is mixed into the silicone part. ( Silicone Oil such as Dimethicone, Cyclomethicone , Silicone Gel ) Stir or blend until homogeneous.

2. Prepare the water portion by bringing water mixed with any ingredients dissolved in water.

3.Take part of the water added to the silicone part By gradually adding little by little and the poor as one flesh and then continue to add Do not add all at once. Because it will take a very long time to blend or stir the recipe until the texture is poor.

For formulas that are Water in Oil (both water and oil, using SiliSolve to coordinate the formula) is recommended. Magnesium Sulfate 1% to help increase the stability of the formula. Reduce the chance of segregation

Compatibility List:

Cyclomethicone all kinds

Dimethicone 1Cs up to 50Cs

Triethylhexanion

Ethanol

Isopropyl Alcohol

Propylene Glycol

Butylene Glycol

Use: It is a water-to-silicone binder. can be used in all formulations

How to mix: Mix in the silicone together, then add water to the water part gradually into the silicone part (if there is oil, mix the oil into the silicone part together first and then mix the water part together). on

Utilization rate: 0.5-1%

Product characteristics: clear liquid

Solubility: can dissolve in silicone

Storage: can be stored at room temperature But close the bottle cap tightly. Then completely covered from sunlight or heat, the product is at least 2 years old.

INCI Name : PEG-10 Dimethicone